Welcome to Anagrammer Crossword Genius! Keep reading below to see if drilled is an answer to any crossword puzzle or word game (Scrabble, Words With Friends etc). Scroll down to see all the info we have compiled on drilled.
drilled
Searching in Crosswords ...
The answer DRILLED has 15 possible clue(s) in existing crosswords.
Searching in Word Games ...
The word DRILLED is VALID in some board games. Check DRILLED in word games in Scrabble, Words With Friends, see scores, anagrams etc.
Searching in Dictionaries ...
Definitions of drilled in various dictionaries:
verb - make a hole, especially with a pointed power or hand tool
verb - train in the military, e.g., in the use of weapons
verb - learn by repetition
Word Research / Anagrams and more ...
Keep reading for additional results and analysis below.
| Possible Dictionary Clues |
|---|
| Simple past tense and past participle of drill. |
| trained in a skill by repetitious practice |
| sow (seed) with a drill. |
| produce (a hole) in something by or as if by boring with a drill. |
| subject (someone) to military training exercises. |
| A tool or machine with a rotating cutting tip or reciprocating hammer or chisel, used for making holes. |
| Instruction or training in military exercises. |
| A predatory mollusc that bores into the shells of other molluscs in order to feed on the soft tissue. |
| Produce (a hole) in something by or as if by boring with a drill. |
| Subject (someone) to military training exercises. |
| Drilled might refer to |
|---|
|
Drilling is a cutting process that uses a drill bit to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multi-point. The bit is pressed against the work-piece and rotated at rates from hundreds to thousands of revolutions per minute. This forces the cutting edge against the work-piece, cutting off chips (swarf) from the hole as it is drilled. * In rock drilling, the hole is usually not made through a circular cutting motion, though the bit is usually rotated. Instead, the hole is usually made by hammering a drill bit into the hole with quickly repeated short movements. The hammering action can be performed from outside the hole (top-hammer drill) or within the hole (down-the-hole drill, DTH). Drills used for horizontal drilling are called drifter drills. * In rare cases, specially-shaped bits are used to cut holes of non-circular cross-section; a square cross-section is possible. |
| Related Answers |
|---|
| fed up |
| FEDUP |
| TIRED |
| UNINTERESTED |